Most of the time, companies will spend a lot of money to buy their forklifts. It is important, therefore to take proper care of your machinery to protect your investment into the long run. It is really a good idea to know the procedures which are undertaken in the care and maintenance of this piece of equipment.
By starting up the forklift and listening closely how it works is amongst the best ways to tell how good the engine is running. Like for example, if there are any misses or knocks, the machine is faulty and this should raise some concerns. In addition listen closely for any squealing sounds which come from the belts since these sounds would provide you with a lot of information.
Several of the main parts needing attention during maintenance comprise the gauges, horn, safety warning devices, the overhead guard and the lights. Any burnt out light bulbs or faulty components need to be replaced as soon as they are noticed. It is also imperative to check the wiring.
When the above components have been checked thoroughly, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Every cell of the battery should be checked so as to make sure that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the equipment and then change the filters. The transmission filter, fuel filters and the hydraulic filter need to be replaced regularly. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
Once the oil change has been done and new filters have been fitted, visually check the drive axle from underneath the machine. Be certain to grease the axle if there is any grease fitting. Check the engine belts for any frays or cracks. If you find any, fix the issue accordingly. After that, check every other part of the machinery including the wheels. If any type of fault or concern is detected, be certain to address it immediately in order to make certain the machine is running at its safest and optimum levels.